Wacker Chemie AG
Wacker Chemie AG: WACKER ENDS Q3 2016 WITH GOOD RESULTS
DGAP-News: Wacker Chemie AG / Key word(s): Quarter Results – AT EUR1.35 BILLION, GROUP SALES FOR Q3 2016 DECLINE BY CLOSE TO 1 PERCENT YEAR OVER YEAR DUE TO PRICES AND BY 3 PERCENT QUARTER OVER QUARTER AMID LOWER VOLUMES – EBITDA OF EUR301 MILLION UP 14 PERCENT VERSUS LAST YEAR DUE TO GOOD COST LEVELS, AND ON A PAR WITH THE PRECEDING QUARTER – NET INCOME FOR Q3 AMOUNTS TO EUR68 MILLION – AT EUR229 MILLION, NET CASH FLOW FOR Q3 2016 SUBSTANTIALLY HIGHER THAN A YEAR AGO – FORECAST UNCHANGED: EBITDA FOR FULL-YEAR 2016 – WHEN ADJUSTED FOR SPECIAL INCOME – SHOULD REACH THE UPPER END OF THE PROJECTED RANGE OF 5 TO 10 PERCENT, WHILE GROUP SALES ARE EXPECTED TO GROW BY A LOW SINGLE-DIGIT PERCENTAGE Munich, October 27, 2016 – Wacker Chemie AG’s Q3 2016 sales were slightly lower year over year, while its earnings before interest, taxes, depreciation and amortization (EBITDA) were substantially higher than last year. The Munich-based chemical group posted sales of EUR1,346.1 million in the reporting quarter (Q3 2015: EUR1,357.9 million), down 1 percent. This slight decrease was chiefly due to lower year-over-year prices for solar silicon, semiconductor wafers and some chemical products. Generally higher volumes did not fully offset these price effects. Relative to the preceding quarter (EUR1,386.2 million), sales were down by 3 percent, primarily due to a decline in volumes for polysilicon and some chemical products. WACKER achieved EBITDA of EUR300.9 million in Q3 2016, 14 percent more than a year ago (EUR264.3 million) and on a par with the preceding quarter (EUR300.0 million). The Group’s EBITDA margin for July through September 2016 was 22.4 percent, compared with 19.5 percent a year ago and 21.6 percent in the prior quarter. The substantial year-over-year increase in EBITDA was primarily attributable to the good cost level. Group earnings before interest and taxes (EBIT) amounted to EUR115.2 million in Q3 2016 (Q3 2015: EUR125.5 million). That was a year-over-year decrease of 8 percent and yielded an EBIT margin of 8.6 percent, compared with 9.2 percent a year ago. Substantially higher depreciation contributed to the year-over-year decline in EBIT. Net income for the reporting quarter amounted to EUR67.5 million (Q3 2015: EUR58.2 million) and earnings per share came in at EUR1.29 (Q3 2015: EUR1.21). The full-year 2016 forecast remains unchanged. The company continues to expect a low single-digit percentage increase in Group sales. EBITDA on a comparable basis – i.e. adjusted to exclude special income from damages received and from terminated contractual and delivery relationships with solar customers – is expected to be between 5 and 10 percent higher than last year. After the positive business performance in the first half of the year, WACKER already announced at the end of July that it expected adjusted EBITDA to come in at the upper end of this range. “Although the underlying conditions were not always easy, WACKER performed well from July through September,” said CEO Rudolf Staudigl in Munich on Thursday. “EBITDA at the chemical divisions and at Siltronic continued to grow both year over year and quarter over quarter. The market environment for our polysilicon business was more difficult, with solar customers ordering substantially less material in September than in the preceding months. Since then, however, there have been increasing indications that demand for solar silicon is picking up again.” Regions Capital Expenditures and Net Cash Flow The Group’s net cash flow was EUR229.9 million in Q3 2016, after EUR36.2 million in Q3 2015. This marked increase was chiefly due to a combination of higher gross cash flow and substantially lower capital expenditures. Employees Business Divisions At WACKER POLYMERS, total sales of EUR308.2 million in the reporting quarter were 2 percent lower than a year ago (EUR313.0 million) and 5 percent below the preceding quarter (EUR325.7 million). Noticeably higher dispersion volumes year over year did not fully compensate for somewhat lower prices in a number of product groups. Negative exchange-rate effects, too, weighed slightly on the sales trend. Compared with Q2 2016, average prices were virtually unchanged, while volumes were lower on balance. The division’s EBITDA grew to EUR73.2 million in the reporting quarter, compared with EUR64.7 million a year earlier – up 13 percent. This gain was essentially due to the low cost level, which in turn benefited from high plant utilization of almost 90 percent. Relative to the preceding quarter (EUR78.2 million), EBITDA decreased by around 6 percent. The decline stemmed not only from lower sales, but also from a quarter-over-quarter increase in the price of ethylene, a base material. The EBITDA margin came in at 23.8 percent in the reporting quarter, after 20.7 percent last year and 24.0 percent in the preceding quarter. WACKER BIOSOLUTIONS generated total sales of EUR54.0 million from July through September 2016. That was 7 percent more than a year ago (EUR50.4 million) and 2 percent more than in Q2 2016 (EUR53.2 million). Higher volumes in a number of segments were the main growth driver. On the other hand, sales were slowed by a slight decline in prices for some products, both year over year and quarter over quarter. EBITDA at WACKER BIOSOLUTIONS reached EUR11.3 million in the reporting quarter, markedly above both last year (EUR7.2 million) and the preceding quarter (EUR9.0 million). This strong growth was fueled by higher sales, by positive product-mix effects and by the division’s good cost situation, which in turn was partly due to high plant utilization. The EBITDA margin came in at 20.9 percent, after 14.3 percent a year ago and 16.9 percent in Q2 2016. WACKER POLYSILICON generated sales totaling EUR253.0 million in the reporting quarter, down 7 percent over both last year (EUR271.4 million) and the preceding quarter (EUR272.2 million). Volumes remained almost unchanged versus last year, while average prices for solar silicon were lower. Compared with the preceding quarter, volumes slowed substantially because customers ordered less solar silicon toward the end of the reporting quarter. WACKER POLYSILICON’s EBITDA totaled EUR82.3 million from July through September (Q3 2015: EUR91.8 million). The main reason for this 10-percent decline was that EUR17.8 million in advance payments retained and damages received were recorded in Q3 2015, whereas no special income of this kind was posted in the reporting quarter. Adjusted for this income, the division’s EBITDA grew by 11 percent year over year. Relative to the preceding quarter (EUR77.7 million), EBITDA was up 6 percent. This increase reflected the fact that no further start-up costs for the new Charleston site were incurred in the reporting quarter. WACKER POLYSILICON’s July-through-September EBITDA margin was 32.5 percent, after 33.8 percent in Q3 2015 and 28.5 percent in Q2 2016. Siltronic generated total sales of EUR236.7 million in Q3 2016, up some 3 percent from last year’s EUR230.6 million. A year-over-year increase in volumes, including inventory sales, compensated for lower average prices. Favorable exchange rates also had a positive impact on the sales trend. Compared with the preceding quarter (EUR229.8 million), sales were also up 3 percent. This rise was due to somewhat higher volumes than in Q2 2016 and positive exchange-rate effects, with average prices remaining virtually unchanged. Reporting-quarter EBITDA at Siltronic reached EUR36.9 million, after EUR29.4 million a year earlier, an increase of 26 percent. In Q3 2015, currency-hedging losses had reduced EBITDA by EUR15.5 million, while the corresponding reporting-quarter figure was only EUR6.8 million. Relative to the preceding quarter (EUR35.0 million), EBITDA was up by around 5 percent, with higher sales and a good cost situation lifting earnings. Siltronic’s EBITDA margin was 15.6 percent in the reporting quarter, after 12.7 percent in Q3 2015 and 15.2 percent in Q2 2016. Outlook EBITDA at WACKER SILICONES should be markedly above last year’s figure. WACKER POLYMERS also expects to post a noticeable increase compared with last year. WACKER BIOSOLUTIONS projects its EBITDA margin to remain more or less unchanged year over year. WACKER POLYSILICON anticipates that its EBITDA will decline significantly year over year, since less special income from advance payments retained and damages received will be posted in 2016 than last year. Full-year EBITDA will also be reduced by start-up costs at the new polysilicon production site in Charleston, Tennessee. Siltronic continues to anticipate a slight improvement in its EBITDA margin compared with last year. Overall, WACKER continues to expect Group sales to rise by a low single-digit percentage in fiscal 2016. EBITDA should climb by between 5 and 10 percent on a comparable basis, i.e. when adjusted to exclude special income. As already announced at the end of July following the company’s positive business performance in the first half of the year, WACKER continues to expect adjusted EBITDA to come in at the upper end of this range. The EBITDA margin, on the other hand, will be somewhat lower, since no major special-income items are expected. Capital expenditures will come to about EUR425 million, substantially lower than a year ago. Depreciation will amount to around EUR720 million, significantly above last year’s level. Group net income should be markedly lower year over year. WACKER expects net cash flow to be clearly positive. Net financial debt at year-end 2016 is anticipated to be slightly lower than last year. Information for editorial offices: The Q3 2016 report is available for download on the WACKER website (www.wacker.com) under Investor Relations. Key Figures of the WACKER Group
1 EBITDA is EBIT before depreciation and amortization. 2 Margins are calculated based on sales. 3 EBIT is the result from continuing operations for the period before interest and other financial results, and income taxes. 4 Sum of cash flow from operating activities (excluding changes in advance payments) and cash flow from long-term investing activities (before securities), including additions due to finance leases. 5 Sum of cash and cash equivalents, noncurrent and current securities, and noncurrent and current financial liabilities. This press release contains forward-looking statements based on assumptions and estimates of WACKER’s Executive Board. Although we assume the expectations in these forward-looking statements are realistic, we cannot guarantee they will prove to be correct. The assumptions may harbor risks and uncertainties that may cause the actual figures to differ considerably from the forward-looking statements. Factors that may cause such discrepancies include, among other things, changes in the economic and business environment, variations in exchange and interest rates, the introduction of competing products, lack of acceptance for new products or services, and changes in corporate strategy. WACKER does not plan to update the forward-looking statements, nor does it assume the obligation to do so. For further information, please contact:
2016-10-27 Dissemination of a Corporate News, transmitted by DGAP – a service of EQS Group AG. |
Language: | English | |
Company: | Wacker Chemie AG | |
Hanns-Seidel-Platz 4 | ||
81737 München | ||
Germany | ||
Phone: | 0049-89-6279-1633 | |
Fax: | 0049-89-6279-2933 | |
E-mail: | investor.relations@wacker.com | |
Internet: | www.wacker.com | |
ISIN: | DE000WCH8881 | |
WKN: | WCH888 | |
Listed: | Regulated Market in Frankfurt (Prime Standard); Regulated Unofficial Market in Berlin, Dusseldorf, Hamburg, Hanover, Munich, Stuttgart, Tradegate Exchange | |
End of News | DGAP News Service |